Limit Of Pan And Tilt; Power Supply Connections - Eneo PXD-2080MIR User Manual

3) Adjust Zoom & Focus.
4) Enter SETUP menu again.
5) Restore FACTORY DEFAULT by MAIN menu-2>CAMERA RESET (See 7.15 CAMERA RESET).
6) Save the restored parameters by moving cursor to SAVE ALL and pressing ● button.
7) Set all other functions if necessary.
8) Save the changes by moving cursor to SAVE ALL and pressing ● button.
9) Exit SETUP menu

Limit of Pan and Tilt

1. Pan limit
Pan is limited to +/- 165°.
Do NOT force to rotate the gimbal over the limit to prevent from the internal damage.
2. Tilt limit
Tilt is limited to 25° min ~ 90° max. with reference to the ceiling when the inclination of camera module
is 0°, that is, the image is aligned horizontally.
CAUTION : Tilt may NOT reach 25° min. if some IR light reflects to the lens when the inclination is NOT 0°.
When Tilt is set to near the minimum limit, examine and verify that NO IR refection occurs.
3. Inclination limit (Horizontal image alignment)
Inclination limited to +/-60° max.

Power Supply Connections

Camera can work with either 24AC or 12VDC, dual voltage power and PoE(IEEE Std. 802.3af).
It is strongly required the polarity-matched connection for 12VDC supply, otherwise IR LEDs will not operate at
night.
Primary and secondary grounds are completely isolated to avoid the possible ground-loop problems.
8