Limit Of Pan And Tilt - Eneo HDD-2000MIR720 Installation And Operating Instructions Manual

Tips for the precise adjustment of lens at outside
. It is recommended to place a ND (Neutral Density) filter in front of the lens.
This results the lens iris open and narrow depth of field and allows the precise focus adjustment.
. When ND filter is NOT available, follow the process carefully.
CAUTION: This process is a little complicated and requires „MUST FOLLOW THE STEPS".
) Enter SETUP menu.
) Select MANUAL at MAIN menu > LENS and Exit SETUP menu.
3) Adjust Zoom & Focus (a).
4) Enter SETUP menu again.
5) Restore FACTORY DEFAULT by MAIN menu > FACTORY > RESET (See 6. MAIN menu).
6) Save the restored parameters by moving cursor to EXIT (SAVE ALL) and pressing button.
7) Set all other functions if necessary.
8) Save the changes by moving cursor to EXIT (SAVE ALL) and pressing button.
9) Exit the SETUP menu.

5.4 Limit of pan and tilt

1. Pan limit
Pan is limited to ±65°.
Do NOT force to rotate the gimbal over the limit to prevent from the internal damage.
2. Tilt limit
Tilt is limited to 5° min ~ 90° max. with reference to the ceiling when the inclination of camera module is 0°,
that is, the image is aligned horizontally.
CAUTION: Tilt may NOT reach 25° min. if some IR light reflects to the lens when the inclination is NOT 0°.
When Tilt is set to near the minimum limit, examine and verify that NO IR refection occurs.
3. Inclination limit (Horizontal image alignment)
Inclination limited to +/-60° max.
39