Task 5: Make Initial Configuration Changes - Supermicro SSH-C48Q Installation Manual

Chapter 3: Installing the Switch
Figure 3-2. System LEDs
PSU1 LED Mod Status LED Mod ATTN LED PSU2 LED

Task 5: Make Initial Configuration Changes

At this point you may need to make a few basic switch configuration changes by
accessing CLI before connecting to the network. The CLI can be accessed two ways
(with optional management card):
1. Using the USB serial port
2. Through an Ethernet port, using Telnet or SSH
The serial port's configuration requirements are as follows: 115200 bps, no parity, one
stop bit, 8 data bits, and no flow control. The serial port does not require a login and
password.
3-5