Changing The Paper Thickness Mode; Job Screen - Panasonic KV-S8147 Operating Manual

5.3.2 Job screen

5.3.1.2 Changing the paper thickness mode

You can select the paper thickness mode depending on the thickness of the document to prevent double
feeding or paper jams.
For details about operation panel, refer to "5 Operation Panel" (page 20).
When the Home screen is on the LCD, press
thickness modes.
You can select one of the following paper thickness modes. The default setting is "Standard paper mode".
Paper thickness mode
Thin paper mode
(20 g/m² – 50 g/m²)
(5.2 lb. – 13.3 lb.)
Standard paper mode
(40 g/m² – 157 g/m²)
(10.6 lb. – 41.8 lb.)
Thick paper mode
(157 g/m² – 255 g/m²)
(41.8 lb. – 68 lb.)
Automatic mode
(20 g/m² – 255 g/m²)
(5.2 lb. – 68 lb.)
Notice
•
The paper thicknesses in the table above are based on high-quality woodfree paper. Documents may
not feed correctly depending on the type of paper used. If that is the case, change the paper
thickness mode, and scan again.
Note
•
The paper thickness mode is enabled when automatic feeding is set.
5.3.2 Job screen
The Job screen is displayed when pressing the Job button (
steps 1 to 4 in "7.3.2.1 Performing push scan" (page 59).
28
or of the cursor button to select one of the paper
LCD display
Use when scanning thin paper or paper with a
rough surface.
(carbonless paper, etc.)
Use when scanning paper of standard thicknesses.
(copy paper, etc.)
Use when scanning thick paper or paper with a
smooth or shiny surface.
(post cards, drawing paper, etc.)
Use when scanning paper of varying thickness.
(The scanning speed will be slow.)
Purpose
). For details about job selection, refer to