Omron V680-HAM91 User Manual page 20
Id flag sensors v680-series id system
Hide thumbs
Also See for V680-HAM91:
- Datasheet (28 pages) ,
- User manual (42 pages) ,
- Instruction sheet (2 pages)
Table of Contents
Advertisement
Section 2
Names and Functions of Components
Mode Setting Switches
Access Mode Setting Switch
Use this switch to set the communications mode for communications with RF Tags.
No.
Name
0
SYNC1
TRIGGER MODE 1 : The ID Flag Sensor starts to communicate with RF Tags when the trigger signal inputs.
1
AUTO1
AUTO MODE 1 : The ID Flag Sensor starts to communicate with RF Tags automatically when the RF Tag comes
in the communication area.
2
SYNC2
TRIGGER MODE 2 : Functional compatible mode with V600 series (V600-HAM91/-HAM81/-HAR91/-HAR81)
3
AUTO2
AUTO MODE 2 : Functional compatible mode with V600 series (V600-HAM91/-HAM81/-HAR91/-HAR81)
4
SYNC3
TRIGGER MODE 3 : Functional compatible mode of V600 series (V600-HAR92)
5
AUTO3
AUTO MODE 3 : Functional compatible mode of V600 series (V600-HAR92)
6
NOISE
NOISE MEASURING MODE : The maintenance mode to measure the environmental noise level.
CHECK
7
---
Setting Prohibit
(The ID Flag Sensor indicates Settings Error.)
8
9
Output Mode Setting Switch
Use this switch to set the output mode and output time width.
No.
0
10 ms OFF DELAY
1
50 ms OFF DELAY
2
500 ms OFF DELAY
3
10 ms
4
50 ms
5
CONTINUOUS
6
---
7
8
9
Note. TRIGGER MODE 1 is not influenced the OUTPUT MODE settings. Set the OUTPUT mode switch either from "0" to "9".
The setting of the mode setting switch is read only when the power supply is turned ON. Therefore, settings cannot be
changed while the power is being supplied. Turn OFF the power supply before changing the settings.
RFID System
18
User's Manual
Refer to the following figure for a set position of the Setting Switch.
Example) When it sets "1".
Refer to the following figure for a set position of the Setting Switch.
Example) When it sets "1".
Setting
Setting
10 ms OFF delay
50 ms OFF delay
500 ms OFF delay
10 ms output
50 ms output
Continuous output
Setting prohibited : except for Trigger Mode1(See Note.)
(The ID Flag Sensor indicates Settings Error.)
Cutting edge
Remarks
Cutting edge
Combination with the access mode
Auto Mode 1, Auto Mode 3, or Trigger Mode 3
Note: A mode setting error will occur if one of the above
access modes is not set.
Auto Mode 2 or Trigger Mode 3
Note: A mode setting error will occur if one of the above
access modes is not set.
p.56
p.60
p.175
p.178
p.181
p.183
p.63
Advertisement
Table of Contents
