Introduction; Manual Organization; Table 1: D9412G/D7412G Operation And Installation Guide Organization - Radionics D9412G Operation And Installation Manual

1.0

Introduction

This manual addresses the operation and installation of the D9412G/D7412G Control/Communicators only, and
should not be used in conjunction with the D9412, D9112, D9112B1, D7412, D7212 or D7212B1 panels.
Throughout this manual, unless expressly stated, the words "panel" and "control/communicator" refer to both
panels (D9412G and D7412G).
Section 2.1 provides an overview of the differences between the D9412G and D7412G panels.
1.1

Manual Organization

This manual is divided into sections and appendices, summarized in the table below.
Section
Description
1 Introduction – provides information on the structure of the manual, lists other literature related
to these Control/Communicators, and describes the FCC rules with which they comply.
2 Overview – provides an overview of the D9412G/D7412G Control/Communicator panels,
including operational specifications, standard and new features.
3 Installation – provides installation instructions for connecting the power terminals plus the status
and battery LEDs.
4 Power Supply – provides information on the primary and secondary modules and instructions
on connecting and programming them.
5 Power Outputs – provides information on the power outputs and instructions on installing the
transformer; explains the status and battery LEDs.
6
Telephone Connections – provides information on connecting the phone line and programming
it for use.
7 On-Board Points – provides information on the on-board points and their parameters.
8 Off-Board Points – provides information on the off-board points and their parameters, including
the installation, wiring and testing of OctoPOPITs.
9 Off-Board Relays – describes the installation and wiring of the D8129 OctoRelay and the D811
Arm Status Relay Module.
10 Arming Devices – describes the installation, wiring, programming and operation of independent
zone control modules.
11 SDI Devices – provides a description and installation instructions for various SDI device
modules.
12
Programmer and Accessory Connections – describes the Programmer Connector and the
Accessory Connector.
13 Faceplates – provides an illustration of each of the panels (D9412G and D7412G).
Appendix
Description
A System Wiring Diagrams – illustrations showing the terminal wiring connections for each of the
panels.
B Point Address Charts – provides ZONEX point addresses for POPITS.

Table 1: D9412G/D7412G Operation and Installation Guide Organization

© 2002 Radionics
D9412G/D7412G Operation & Installation Guide
Page 9
D9412G/D7412G
Introduction
43488D