Programmer And Accessory Connections; Programmer Connector; Programmer Access Reports; Accessory Connector - Radionics D9412G Operation And Installation Manual

12.0 Programmer and Accessory Connections

12.1

Programmer Connector

The procedure below shows how to connect
and disconnect the programmer. Refer to
the D5200 Operation Manual for complete
information on using the D5200
programmer.
Lock Reset Pin: See Figure 21 .
1.
2. Connect the D5200 Data/Power cord
into the programmer connector.
3. Perform the desired programming
function (send or receive program).
4. Disconnect the programmer.

12.1.1 Programmer Access Reports

When a program is sent to the panel, the
panel sends a PROG ACCESS OK report ten
seconds after the handler is exited or when
the programmer is disconnected. The
prompt in Routing must be programmed
YES for this report to be sent.
12.2

Accessory Connector

Use the Accessory Connector to connect
the panel to the D928 Dual Phone Line
Switcher. The Accessory Connector is on the
bottom right corner of the I/O board. See
Figure 22 . The D928 allows the panel to use
two telephone lines to transmit reports.
See section 6.12 D928 Dual Phone Line
Switcher for installation and operating
instructions.
© 2002 Radionics
Programmer and Accessory Connections
Disable All Except Battery
Charging And Programming
PERIPHERAL DEVICE CONNECTIONS
RED
YELLOW
GREEN
BLACK
D9412G/D7412G Operation & Installation Guide
Page 61
Reset Pin
32
POWER +
DATA BUS A 31
30
DATA BUS B
29
COMMON

Figure 21: Reset Pin

NEX POWER +
ZONEX COMMON
Point 8
GND FAULT
Detect
D
I
S
A
B
L
L
GRN
E
E
Accessory
Connector

Figure 22: Programmer and Accessory Connections

D9412G/D7412G
RESET PIN
LOCKED (CLOSED)
RESET PIN
NORMAL (OPEN)
FOR NORMAL
PANEL
OPERATION
26
25
NEX IN 2
24
23
PROG
CONN
Programming
Connector
43488D