Specifications; Environmental Specifications; Mechanical Specifications; Power Supply Specifications - HP ProLiant DL60 Gen9 User Manual

Specifications

Environmental specifications

Specification
Temperature range*
Operating
Nonoperating
Relative humidity
(noncondensing)
Operating
Nonoperating
* All temperature ratings shown are for sea level. An altitude derating of 1.0°C per 304.8 m (1.8°F per
1000 ft) to 3048 m (10,000 ft) is applicable. No direct sunlight allowed. Maximum rate of change is 20°C
per hour (36°F per hour). The upper limit and rate of change might be limited by the type and number of
options installed.
For certain approved hardware configurations, the supported system inlet temperature range is extended:
•
5°C to 10°C (41°F to 50°F) and 35°C to 40°C (95°F to 104°F) at sea level with an altitude derating of
1.0°C per every 175 m (1.8°F per every 574 ft) above 900 m (2953 ft) to a maximum of 3048 m
(10,000 ft).
•
40°C to 45°C (104°F to 113°F) at sea level with an altitude derating of 1.0°C per every 125 m (1.8°F
per every 410 ft) above 900 m (2953 ft) to a maximum of 3048 m (10,000 ft).
The approved hardware configurations for this system are listed on the Hewlett Packard Enterprise
website (http://www.hpe.com/servers/ASHRAE).

Mechanical specifications

Specification
Height
Depth
Width
Weight (approximate range)

Power supply specifications

Depending on the installed options and/or the regional location where the server was purchased, the
server is configured with one of the following power supplies:
•
HPE 550 W Power Supply (PN 730941-B21)
Value
—
10°C to 35°C (50°F to 95°F)
-30°C to 60°C (-22°F to 140°F)
—
Minimum to be the higher (more moisture) of
-12°C (10.4°F) dew point or 8% relative
humidity
Maximum to be 24°C (75.2°F) dew point or
90% relative humidity
5% to 95%
38.7°C (101.7°F), maximum wet bulb
temperature
Value
4.29 cm (1.69 in)
60.70 cm (23.90 in)
43.46 cm (17.11 in)
9.00 kg to 17.00 kg (19.82 lb to 37.44 lb)
Specifications 109