Remove The Pci Riser Cage - HP ProLiant DL60 Gen9 User Manual

To install the component:
Install the air baffle.
1.
Install the access panel (on page 19).
2.
Do one of the following:
3.
Slide the server into the rack.
o
Install the server into the rack.
o
Power up the server (on page 15).
4.

Remove the PCI riser cage

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to the server or expansion boards, power down the server,
and disconnect all power cords before removing or installing the PCI riser cage.
Power down the server (on page 15).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 15).
o
Remove the server from the rack (on page 18).
o
Remove the access panel (on page 18).
4.
Disconnect all cables connected to existing expansion boards.
5.
Remove the secondary PCI riser cage or PCI blank.
6.
Operations 21