Table of Contents
Advertisement
Specifications
Environmental specifications
Specification
System Inlet Temperature, Standard Operating Support
Operating
Non-operating
Relative humidity (non-condensing)
Operating
Non-operating
Altitude
Operating
Non-operating
1
All temperature ratings shown are for sea level. An altitude derating of 1.0°C per 305.0 m (1.8°F per 1000 ft) to 3050 m (10,000 ft) is
applicable. No direct sunlight allowed. Maximum rate of change is 20°C per hour (36°F per hour). The upper limit and rate of change might
be limited by the type and number of options installed. System performance during standard operating support may be reduced if operating
with a fan fault or above 30°C (86°F).
The approved hardware configurations for this system are listed on the Hewlett Packard Enterprise website.
Value
1
—
10°C to 35°C (50°F to 95°F)
-30°C to 60°C (-22°F to 140°F)
—
Minimum to be the higher (more moisture) of -12°C (10.4°F)
dew point or 8% relative humidity
Maximum to be 24°C (75.2°F) dew point or 90% relative
humidity
5 to 95% relative humidity (Rh), 38.7°C (101.7°F) maximum
wet bulb temperature, non-condensing.
—
3050 m (10,000 ft)
This value may be limited by the type and number of options
installed. Maximum allowable altitude change rate is 457
m/min (1500 ft/min).
9144 m (30,000 ft)
Maximum allowable altitude change rate is 457 m/min (1500
ft/min).
161
Specifications
Advertisement
Table of Contents
