Item Description Health LED of Node 2 Health LED of Node 4 Thumbscrews for rack mounting Hard disk drive (HDD) activity LED Hard disk drive (HDD) location/error LED Hard disk drive (HDD) bay IMPORTANT: From the front side view, the right node is node 2 and the left node is node 4.
For safety information and detailed procedures relating to • installation of options, refer to any installation instructions that came with the option, as well as the HP ProLiant DL170h G6 series Server Maintenance and Service Guide. • For safety information and detailed procedures related to the rest of the steps listed in the “Configuring the Server”section, refer to...
R efer to the HP ProLiant DL170h G6 Server Easy Set-up CD for To remove the top cover: • additional information and updates not provided in this Turn the screw to the side with the unlock sign with the T-10- wrench installation sheet.
DIMM population order processor socket 2: 8A, 5B, 2C, 7D, Installing a Processor 4E, 1F, 6G, 3H. The HP ProLiant DL170h G6 server supports Nehalem Processors High Figure 7 Population Order of DIMM Sockets Wattage 95W (Dual CPUs 64-bit), Nehalem Processors 80W (Dual CPUs 64-bit), and Nehalem Processors Low Wattage 65W (Dual CPUs 64-bit).
Page 6
Figure 10 Reinserting the processor Press the tabs on the processor installation tool to separate it from the processor, and then remove the tool. Figure 12 Removing the tool Align the processor installation tool with the socket, and then install the processor. THE PINS ON THE SYSTEM BOARD ARE VERY FRAGILE AND EASILY DAMAGED.
CAUTION: To prevent the heat sink from tilting to one side during installation/removal, turn each screw a couple of turns, For additional documentation, refer to HP ProLiant DL170h G6 Easy alternatively between both of them, and then apply the final Set-up CD.