Processor Option - HP ProLiant DL60 Gen9 User Manual

Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 15).
o
Remove the server from the rack (on page 18).
o
Remove the access panel (on page 18).
4.
Open the DIMM slot latches.
5.
Install the DIMM.
6.
Install the access panel (on page 19).
7.
Do one of the following:
8.
Slide the server into the rack.
o
Install the server into the rack.
o
Power up the server (on page 15).
9.
After installing the DIMMs, to configure memory protection mode, use RBSU.

Processor option

The server supports single and dual-processor operations.
Installing a second processor
If you are installing a second Intel Xeon E5-2600 v3 processor in the processor socket 2, follow the
procedure in this section.
Upgrading from an existing E5-2600 v3 processor to a E5-2600 v4 processor
This server only supports E5-2600 v4 processors with a TDP specification of 105 W or less. See the
Customer Advisory (c04849981)
(http://h20564.www2.hpe.com/hpsc/doc/public/display?docId=c04849981) for the latest information.
Read this Customer Advisory in its entirety before selecting a processor upgrade option.
For more information about product features, specifications, options, configurations, and compatibility,
see the product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).
Hardware options installation 55