Install The Air Baffle - HP ProLiant DL60 Gen9 User Manual

To remove the component:
Power down the server (on page 15).
1.
If you are performing a non-hot-plug procedure, remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 15).
o
Remove the server from the rack (on page 18).
o
Remove the access panel (on page 18).
4.
Remove the air baffle.
5.

Install the air baffle

CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components,
minimize the amount of time the access panel is open.
l
Operations 20