Review Configuration Data - Emerson Rosemount 3051S Series Reference Manual

Rosemount 3051S Series
REVIEW
CONFIGURATION DATA
3-4
NOTE
Information and procedures in this section that make use of HART
Communicator fast key sequences and AMS assume that the transmitter and
communication equipment are connected, powered, and operating correctly.
The following is a list of factory configurations. These can be reviewed by
using the HART Communicator or AMS.
HART Communicator v1.8
Enter the fast key sequence to view the configuration data.
Fast Keys
Manufacturer "Rosemount"
Transmitter model
Measurement type
Module configuration type
Range
PV Unit
PV Lower Sensor Limit (LSL)
PV Upper Sensor Limit (USL)
PV Lower Range Value (LRV)
PV Upper Range Value (URV)
PV minimum span
Lower sensor trim point
Upper sensor trim point
Sensor trim calibration type
Transfer function
Damping
Alarm direction
High Alarm (Value)
Low Alarm (Value)
High saturation
Low saturation
Alarm/Saturation type
Sensor S/N
Isolator material
Fill fluid
Process connector
Process connector material
AMS v7.0
Right click on the device and select "Configure" from the menu. Select the
tabs to review the transmitter configuration data.
1, 5
O-Ring material
Drain/Vent material
Number of diaphragm seals
Seal type
Remote seal isolator material
Seal fill fluid
Tag
Date
Descriptor
Message
Write protect
Meter type
Local keys
Universal revision
Field device revision
Software revision
Hardware revision
Physical signal code
Final assembly number
Device ID
Burst mode
Burst option
Poll address
Number req preams
Multisensor device
Command #39, EEProm Control required
Distributor
Reference Manual
00809-0100-4801, Rev CB
January 2007