Danfoss ECL Comfort 296 Operating Manual page 112

Operating Guide ECL Comfort 210/296/310, application A230
Alarm overview, list:
Alarm Description:
no.:
2
A230.1 and A230.4:
Temp. monitor, circuit 1
9 Pressure
16
Floor drying,
circuit 1
32
T sensor defect
To find the reason for an alarm:
• select MENU
• select 'Alarm'
• select 'Alarm overview' . A "bell" will be shown at the alarm in
question.
Alarm overview (example):
2: Max. temp.
32: T sensor defect
The numbers in the 'Alarm overview' refer to the alarm number
in the Modbus communication.
To reset an alarm:
When the "bell" is present to the right of the alarm line, place the
cursor at the alarm line in question and press the dial.
To reset alarm 32:
MENU > Common controller settings > System > Raw input
overview: The sensor in question is marked and the alarm can be
reset.
Parameters indicated with an ID no. like "1x607" mean a universal
parameter.
x stands for circuit / parameter group.
MENU > Settings > Alarm
Alarm high
When the measured value gets higher than the set value, the alarm will
be activated.
See Appendix "Parameter ID overview"
Value: Set the alarm value
112 | © Danfoss | 2017.05
Alarm Sensor
ref.:
type:
1 S3
1
S8
1
S3
2
all
1x614
VI.LG.H4.02