Maintenance - Proxxon DSH Manual

Inside cuning
@E!
Always pullthe mains plug out before removing the saw
blade.
1. Drill a hole into the inner section of the part to be cut out.
Choosing the saw blade
Spacing
teetMnch
a p p r o x . 1 0
approx. l8
approx. 25
Materlal
wood from 6 mm up to 50 mm
fine work, wood up to 6 mm
Plaslic material, glass fiber reinforced
plastic material, non-ferrous metals.
plexiglass
EC Declaration ol Conformity
We declare in sole responsibility,
that this product is in
accordance with the following Ec-regulations:
. EG-EMV regutation 89/336, reptaced by
93/68
. EG-fow vollage regulation 73/23, replaced
by 9U6g
. EG-machine regulation g9/992, replaced
by 91/36g,
9U44 and 93/68
Dipl. Ing. Martin Faßbender
,A Qr\*ann
PROXXON S.A.
Department "Equipment safety"
We reserve the right for technical modifications without prior
notilication.
Choosing the motor speed
Step
Materlat
1 900 strokes steel, brass, non-ferrous metals, glassfiber,
reinf orced, plastic material,
2 1500 strokes aluminium, wood, styrene, rubber, leather,
cork
Reduce the saw blade tension until the saw blade can
be easily unhooked.
Place the work piece onto the work table with the oore
above the opening in the table.
Insert the saw blade through the bore
(Fig. 10). Reattach the saw btade at the top and the
bottom and retension it correcfly.
Cut the opening.
Maintenance
Always pullthe mains plug out before carrying out
maintenance and repair woks.
After working with the machine clean off all saw dust with a
brush or a soft cloth.
2.
4 .
5 .
- 1 1