Sawing ……………………………………………………13 band it will also cut glass and ceramics. Free hand sawing ………………………………………13 The MBS 240/E has a 230 volt motor with electronic Sawing with the angle stop ……………………………13 speed control to set the correct band speed for optimal Mitre cuts …………………………………………………13...
Technical data Assembling the work table Unscrew the brass screw plug 1 at the sawing gap (Fig. 3) Rated voltage: 220-240 Volt 50 Hz of the work table. Rated input: 85 watt 1. Insert the work table 3 (Fig. 4) into the designated cut- Protection class: IP 24 out and fasten with the star knob screw (2) and the flat...
(B) loosens it. A too greatly tensioned saw band can tear apart and damage When using the Proxxon CW-matic vacuum cleaner, man- the device. ual switching on and off is no longer necessary. The CW- 3.
Page 8
8. Check if the band runs correctly in the lower guide 1 1. Unscrew the four Allen screws 2 (Fig. 12) and remove (Fig. 15). The guide slot must be exactly perpendicu- the housing cover 1. lar. Adjust the band guide by releasing the clamping 2.
- as long as the machine is still running! This could result in injuries. Product designation: MBS 240/E The machine is largely maintenance free. To ensure a long service life, however, the machine should be cleaned Article No.:...
Page 14
Service note All PROXXON products are thoroughly inspected after production. Should a defect occur nevertheless, please contact the dealer from whom you purchased the product. Only the dealer is responsible for handling all legal warranty claims which refer exclusively to material and manufacturer error.