Ec Declaration Of Conformity; Maintenance - Proxxon DS 230E Manual

Hide thumbs Also See for DS 230E:

Manual (45 pages)

Table of Contents

Enlarged version

vacuum cleaner. To this end, connect the vacuum cleaner at the pipe

union 19 (Fig. 1) using the attached rubber adapter.

Working with the mechanical fret saw

1. Set the stroke rate with the speed regulation 16 (Fig. 1). High stroke

rate for wood, aluminum, brass and boards. Low stroke rates for

plastics, particularly thin materials and for extremely fine work.

2. Adjust the saw blade guide. For this, release screw 6 (Fig. 1), set the

saw blade guide 17 (Fig. 1) as deeply as possible and re-tighten the

screw.

3. When sawing, press the work piece firmly onto the table, in order to

avoid vibration. Then saw the work piece carefully and with little feed.

Thus: high pressure against the base plate – little pressure against the

saw blade.

4. When sawing with the longitudinal stop, release the clamping screw 1

(Fig. 6), set the stop and retighten the clamping screw.

5. When sawing with the angle stop, release the clamping screw 1 (Fig.

7), adjust the angles according to the scale and retighten the clamping

screw. Then press the work piece lightly against the stop and slide the

stop along the groove 2.

Please remember that with a mechanical fret saw, the saw blade

fundamentally tries to follow the grain of the wood. For frequent

even cuts a circular saw is there-fore always preferable to a

mechanical fret saw.

Maintenance

Pull out the mains plug prior to commencing all maintenance and

repair work.

Replacing the toothed belt

If the toothed belt becomes worn it is possible to change it yourself. You

can order replacement belts from the PROXXON central service team.

1. Remove mains plug.

2. Remove the saw blade.

3. Unscrew screws 2 (Fig. 8) in the base plate 1.

4. Unscrew screws 4 in the lower part of the housing 3.

5. Unscrew screws 3 (Fig. 9) and remove the base plate 2 from the

transmission 1.

6. Unscrew screws 1 (Fig. 10) and remove the guide plate 2 with piston

7. Unscrew the motor attachment screws 4 inside the transmission

case 8 and pull out the motor 5 with pinion.

8. Unscrew the threaded pins of the pulley 6 using an Allen key and pull

out the shaft with eccentric cam 7.

9. Remove pulley 6 and insert new toothed belt.

10. Position the pulley 6 with toothed belt in the transmission case in

such a way that the shaft with eccentric cam can be re-inserted.

11. Insert the motor 5 back into the transmission case and put the

toothed belt on the motor pinion (this requires sensitive fingers and

patience).

12. Re-bolt the motor with the transmission case.

13. Grease piston 3 with the eccentric cam, fasten guide

plate 2.

14. Tighten the threaded pin of the pulley 6.

15. Re-screw the transmission to the base plate, attach the lower part

of the housing and fasten the base plate to the housing.

Note:

Important

Disposal:

Please do not dispose of the device in domestic waste! The device

contains valuable substances that can be recycled. If you have any

questions about this, please contact your local waste management