Ec Declaration Of Conformity; Maintenance - Proxxon KS 230 Manual

Hide thumbs

Table Of Contents

Table of Contents

Available languages

Enlarged version

Working with the MICRO-circular saw

Sawing with the longitudinal stop

1. Release the clamping screw 1 (Fig. 5), set stop and again

retighten the clamping screw (the max. work piece width

amounts to 70 mm).

Sawing with the angle stop

1. Release the clamping screw 1 (Fig. 6), set the angles

according to the scale and retighten the clamping screw.

Then push the work piece lightly against the stop and

guide the stop along groove 2.

Overload display

Your electrical tool is equipped with an optical display that

signals when the device is too heavily loaded during work.

The LED item 13 (see fig. 1) lights up green once the device

is switched on in normal mode. When the device is over-

loaded (e.g. when the feed rate of the workpiece is too

high or the blade is worn etc.), the colour changes from

green to red. This is a sign that the device is in an operating

condition for which it is not designed. The mechanics and

electrics are very heavily loaded. This operating condition

should, therefore, be avoided. It is then advisable to work

with a lower feed rate, and possibly to replace worn saw

blades or to select a workpiece with reduced depth of

the cut etc.

Maintenance

Important

Pull out the mains plug prior to commencing all

maintenance and repair work.

Replacing the toothed belt

If the toothed belt becomes worn it is possible to change it

yourself. You can order replacement belts from the PROXXON

central service.

1. Remove mains plug.

2. Remove the saw blade.

3. Unscrew screws 2 and 4 (Fig. 7a).

4. Unscrew screws 3 and remove the base plate from the

transmission.

5. Release the threaded pin 7 (Fig. 7b) using 2 mm hexagon

key and pull out the shaft 6.

6. Release the motor screws 9 and remove the motor from

the transmission.

7. Remove the pulley 8 and insert a new toothed belt.

8. Install the pulley 8 with toothed belt in the transmission

casing.

9. Insert the toothed belts on the motor pinions and

reconnect the motor to the transmission

10. The rest of the assembly follows in reverse order.

Disposal

Please do not dispose of the device in domestic waste! The

device contains valuable substances that can be recycled. If

you have any questions about this, please contact your local

waste management enterprise or other corresponding

municipal facilities.