Performance Tests; Test Equipment - Fluke 6060B Instruction Manual

Section
4A
Performance
Tests
4A-1.
INTRODUCTION
The
information
in
the following
paragraphs describes the performance
tests
for the key
parameters of the Signal Generator, using the
instrument specifications as the
performance
standard.
These covers-on performance
tests
may
be used
as
an acceptance
test
upon
receipt
of
the instrument, as
an
indication that repair
and/or
calibration
is
required, or as a
performance
verification after
completing
repairs or
calibration of the
instrument. Individual
performance
tests
can be used as troubleshooting
aids.
The
Signal Generator being
tested
(UUT)
must be
warmed
up
with
all
covers
in
place for
at least 20 minutes before
starting the
performance
tests.
Periodic calibration
is
recommended
once a
year.
4A-2.
TEST EQUIPMENT
Table 4A-1
gives
a
list
of the
recommended
test
equipment
for the performance
tests,
adjustment procedures,
and
for troubleshooting
the Generator. Figure
4A>1 shows
a
Two-Turn
Loop,
Figure 4A-1.
Two-Turn Loop
4A-1