Modulation Entry; Entry - Fluke 6060B Instruction Manual

INSTALLATION AND
OPERATION
Table 2-8. IEEE-488
Commands
(cont)
UNCAL lU
none none Interrogates the
uncalibrated output
error
codes.
The Generator responds with
three octal fields:
"AAAAA,BBBBB,CCCCC". See Table 2-5
for
a
list of uncal error codes.
Software
IV
none none
Interrogate the software version. The
Version
Generator responds with the status
message: "Vxx.x" where x's are decimal
digits representing the current
software revision level.
HEMORY ENTRY
Recall.
RC int
none Recall
the front panel setup stored at
the memory location specified
by int.
Store ST
int none
Store the current front panel setup at
the memory location specified by int.
Sequence
SO
none none
Sequence (recall) to the next
higher memory Location.
MODULATION ENTRY
Program AM AH float PC Program AM depth In
percent.
External AM
AE 0/1
none
Disable/enable external AM
modulation.
Internal AM A1 0/1 none
Disable/enable internal AM modulation.
Program
FH FM
float Program FH
deviation
in
units of:
6Z
gigahertz
M2
megahertz
KZ
kilohertz
HZ
hertz
External FM FE 0/1
none
Disable/enable external
FM
modulation.
Internal
FH
FI
0/1
none
Disable/enable internal
FM
modulation.
Program MR 0/1 none
Program modulation frequency
Hod Freq to 400 Hz/1000
Hz.
Program
Mod Freq
MF float
Program modulation frequency
in
units of:
62
gigahertz
MZ
megahertz
KZ
kilohertz
KZ hertz
MONITOR COMMANDS
Input
Bit
IB
none BIT Respond with the
value
of the
Desig-
designated hardware bit.
nator
Output Bit
OB
0/1
BIT Set the
designated hardware
Desig- bit to 0 or
1.
nator
2-33