Advertisement
QuickSpecs
Configuration Information - Factory Integrated Models
This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are
ordered, Hewlett Packard Enterprise recommends the use of an HPE approved configurator. Contact your local sales
representative for information on configurable product offerings and requirements.
1. Factory Integrated Models must start with a CTO Server.
2. FIO indicates that this option is only available as a factory installable option.
3. All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard drives
ordered with the server.
4. Some options may not be integrated at the factory. Contact your local sales representative for additional information.
Step 1: Base Configuration (choose one of the following configurable models)
[Chassis]
SKU Number
Processor
DIMM Slots
Storage Controller
PCIe
4 PCIe 3.0 slots (all 4 available if second processor is chosen, which also enables
Drive Cage
8SFF Hot Plug (Upgrades possible with +16SFF optional or +10 optional with
Network Controller
Flexible LOM slot (various options can be chosen for networking; NIC cards also
Fans
Management
Embedded Remote Support Technology, HPE Insight Control Server Provisioning,
USB
(Base Configuration Continued)
Intel® C610 Chipset
(2) video ports (1 front optional via the Universal Media Kit upgrade option, 1 rear)
(1) dual microSD card slot
(1) Trusted Platform Module (TPM) connector
BIOS Legacy mode (field configurable) or Unified Extensible Firmware Interface (UEFI) mode (default)
Easy Install rails and cable management arm
NOTE: PCIe slot availability is dependent on the number of processors installed. Please refer to the "Expansion slots"
section for more details.
NOTE: A minimum of two processors are required. The system may have three or four processors installed.
Step 2: Choose Required Options (only one of the following from each list unless otherwise
noted)
HP ProLiant DL560 Gen9 Configure-to-order Server
2U Server Chassis with 2 processor slots available; 4 processor configuration
would require optional HPE Proliant DL560 Gen9 CPU Mezzanine Board kit
24 DIMM slots for RDIMM, LRDIMM DDR4 Memory
HPE Dynamic Smart Array B140i
+3 PCI 3.0 slots with optional Secondary Riser Kit upgrade)
optional Universal Media Bay Kits)
available via expansion slots)
4 Hot Plug Fans (eight rotors with N+1 redundancy), front accessible
HPE Integrated Lights-Out 4 (iLO4) standard management, HPE iLO4
HPE Insight Online, HPE Active Health System, System Insight Display
(8) USB 2.0 ports (2 front, 4 rear, 2 internal)
742657-B21
HPE ProLiant DL560 Generation9 (Gen9)
Page 18
Advertisement
