Advertisement
QuickSpecs
Configuration Information - Factory Integrated Models
This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid
configurations are ordered, Hewlett Packard Enterprise recommends the use of an HPE approved
configurator. Contact your local sales representative for information on configurable product offerings and
requirements.
1. Factory Integrated Models must start with a CTO Server.
2. FIO indicates that this option is only available as a factory installable option.
3. All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of
initial hard drives ordered with the server.
4. Some options may not be integrated at the factory. Contact your local sales representative for
additional information.
Step 1: Base Configuration (choose one of the following configurable models)
[Chassis]
SKU
Number
Processor
2U Server Chassis with 2 processor slots available; 4 processor configuration would
DIMM Slots
Storage
Controller
PCIe
4 PCIe 3.0 slots (all 4 available if second processor is chosen, which also enables +3
Drive Cage
8SFF Hot Plug (Upgrades possible with +16SFF optional or +10 optional with optional
Network
FlexibleLOM slot (various options can be chosen for networking; NIC cards also
Controller
Fans
Management
iLO Management (standard), Intelligent Provisioning (standard), iLO Advanced
USB
7 USB ports total. 3 USB 2.0 Ports: 2 rear; 1 internal. 4 USB 3.0 Ports: 1 front; 2 rear, 1
(Base Configuration Continued)
Intel® C610 Chipset
(2) video ports (1 front optional via the Universal Media Kit upgrade option, 1 rear)
(1) dual microSD card slot
(1) Trusted Platform Module (TPM) connector
BIOS Legacy mode (field configurable) or Unified Extensible Firmware Interface (UEFI) mode (default)
Easy Install rails and cable management arm are optional
NOTE: PCIe slot availability is dependent on the number of processors installed. Please refer to the
"Expansion slots" section for more details.
NOTE: For the DL560 Gen9, the number of processors can be one, two or four installed. For four
processors, the HP ProLiant DL560 Gen9 CPU Mezzanine Board kit is required.
Step 2: Choose Required Options (only one of the following from each list unless
otherwise noted)
HPE ProLiant DL560 Gen9 Configure-to-order Server
require optional HPE Proliant DL560 Gen9 CPU Mezzanine Board kit
24 DIMM slots for RDIMM, LRDIMM DDR4 Memory
HPE Dynamic Smart Array B140i
PCI 3.0 slots with optional Secondary Riser Kit upgrade)
Universal Media Bay Kits)
available via expansion slots)
6 Hot Plug Fans (with N+1 redundancy)
(optional), Insight Control (optional), HPE OneView (optional)
DA - 15296 Worldwide QuickSpecs — Version 10 — 6.20.2016
HPE ProLiant DL560 Generation9 (Gen9)
742657-B21
internal
Page 20
Advertisement
