Table of Contents
Advertisement
QuickSpecs
Configuration Information - Factory Integrated Models
NOTE: This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are
ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for information on Factory
Integrated Model product offerings and requirements.
NOTE: HP does not allow factory integration of options into standard models listed above.
Configure-to-order servers must start with a Factory Integrated Model (CTO) Blade.
NOTE: FIO indicates that this option is a Factory Installable Option.
Step 1: Base Server Blade Configuration (Select a configurable Blade)
HP Models
Step 2: Choose Required Options (one of the following from each list unless otherwise
noted):
HP Processors
HP Memory
HP ProLiant BL620c G7 CTO Blade
Configurable model ships with:
1.
Four (4) integrated HP NC553i 10Gb FlexFabric Converged Network Adapters
supporting 10Gb/1Gb autosensing Ethernet, FCoE, Flex-10, TCP/IP offload
engine, and hardware-based accelerated iSCSI
2.
One (1) 10/100 network adapter dedicated to iLO 3 Management
3.
One (1) Integrated SAS version 2.0 (6Gb) HP Smart Array P410i Controller with
RAID 0 and 1
NOTE: The P410i is configured with no cache allowing the end user to select what
cache option of the three different options they desire (if cache is desired in the
first place).
4.
Two (2) cache slots for FBWC battery options.
NOTE: The server supports up to a total of two (2) FBWC options including one
added to the P410i
5.
Two (2) small form factor hot-plug SAS/SATA/SSD hard drive bays
6.
Three (3) I/O expansion slots
7.
One (1) integrated Lights-Out 3
8.
Integrated USB, MicroSDHC, and TPM connectors
NOTE: The BL620c G7 supports one or two processors.
NOTE: All processors within the server must be identical.
NOTE: All Configure-to-Order processor kits contain one (1) processor.
NOTE: If two processors are desired, select one xxxxxx-L21 kit and one xxxxxx-B21 kit.
8 core processors
Intel Xeon L7555 (8 core, 1.86 GHz, 24MB L3 cache, 6.40GT/s QPI, 95W) BL620c G7 1P
FIO Kit, 603612-B21 for second processor
6 core processors
Intel Xeon E7530 (6 core 1.86 GHz, 12MB L3 cache, 5.86GT/s QPI, 105W) BL620c G7 1P
FIO Kit, 603610-B21 for second processor
NOTE: All DDR3 memory option kits consist of one RDIMM per kit.
NOTE: See the "Memory" section for memory guidelines, installation rules, and
additional general information.
HP 4GB (1x4GB) Dual Rank x4 PC3-10600 (DDR3-1333) Registered CAS-9 Memory Kit
HP 8GB (1x8GB) Dual Rank x4 PC3-10600 (DDR3-1333) Registered CAS-9 Memory Kit
DA - 14179 Worldwide — Version 2 — December 28, 2012
HP ProLiant BL620c Generation 7 (G7) Server Blade
Carrier Grade Supplement
600332-B21
603612-L21
603610-L21
500658-B21
500662-B21
Page 16
Advertisement
Table of Contents
