Copying Files - Cisco 12404 Installation And Configuration Manual

Chapter 3 Installing the Cisco 12404 Internet Router

Copying Files

To disable the break function and enable the boot system flash device:filename
command, enter the config-register command at the global configuration mode
prompt with the configuration register value, as shown below:
Filo(config)# config-reg 0x0102
Ctrl-Z
Filo#

Copying Files

It is a good idea to copy a new Cisco IOS software image to Flash memory when
a new image becomes available, or when you want to back up the image.
The information in this section enables you to copy any type of file to the Flash
memory SIMM on the RP or to a PCMCIA Flash memory card inserted in either
slot 0 or slot 1.
You cannot copy a new Cisco IOS software image into the onboard Flash memory
Caution
SIMM (also referred to as bootflash) while the system is running from onboard
Flash memory.
To avoid losing valid Cisco IOS images upgrade your Cisco IOS software images
in Flash memory one at a time; and your PCMCIA-based Flash memory
separately from the onboard Flash SIMM (bootflash) on the RP.
To copy a file to Flash memory, enter the following command at the privileged
EXEC mode prompt on your system console:
filename filename
Filo# copy tftp: [bootflash:|slot0:|slot1:]
Cisco 12404 Internet Router Installation and Configuration Guide
3-77
OL-11636-01