Copying Cisco Ios Software Images - Cisco 12404 Installation And Configuration Manual

Chapter 3 Installing the Cisco 12404 Internet Router
Step 4

Copying Cisco IOS Software Images

OL-11636-01
Reboot the system.
As future releases of Cisco IOS software become available, you will receive these
images as a file booted from a network TFTP server, as a file on a floppy disk, or
as a file on a Flash memory card.
This section give you information on how to use a newly released Cisco IOS
software image on a Flash memory card in a system that has an older Cisco IOS
image residing on a Flash memory card inserted in PCMCIA slot 0 and a default
Cisco IOS software boot image stored in the onboard Flash memory SIMM on the
RP.
In this procedure, you will copy an updated Cisco IOS software image from a new
Flash memory card onto a Flash memory card containing an old Cisco IOS
software image. In this example, the following filenames apply:
image.new—The new image on the new Flash memory
•
image.old—The old image on the old Flash memory card inserted in
•
PCMCIA slot 0.
image.boot—The bootable Cisco IOS software image stored in the onboard
•
Flash memory SIMM. (This image is used by default to boot the system if no
other bootable image is available.)
Cisco 12404 Internet Router Installation and Configuration Guide
Copying a Cisco IOS Software Image
3-80