Cisco 12404 Installation And Configuration Manual page 166

Chapter 3 Installing the Cisco 12404 Internet Router
Where:
startup-config
[slot0: | slot1:]filename
An example of the copy startup-config slot0:filename command follows:
Filo# copy startup-config slot0:myfile2
20575008 bytes available on device slot0, proceed? [confirm]
Address or name of remote host [1.1.1.1]?
Loading new.image from 1.1.1.1 (via Ethernet0):
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
[OK - 7799951/15599616 bytes]
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
Filo#
In this example, the exclamation points
CCCCC
has been copied correctly.
You can also copy the running configuration (located in DRAM) to a Flash
memory card, as shown in the following section,
from RP DRAM to a Flash Memory Card, page
To further verify that the configuration file was copied correctly to the Flash
Step 3
memory card in slot 0, enter the dir command:
Filo# dir slot0:
-#- -length- -----date/time------ name
1
3
4
5
9197156 bytes available (11381148 bytes used)
Filo#
OL-11636-01
characters signify the calculation of the CRC, which verifies that the file
5200084 May 10 2002 19:24:12 gsr-p-mz.112-8
1215 May 10 2002 20:30:52 myfile1
6176844 May 10 2002 23:04:10 gsr-p-mz.112-8.1
1186 May 10 2002 16:56:50 myfile2
Cisco 12404 Internet Router Installation and Configuration Guide
Copying a Cisco IOS Software Image
Specifies the source of the file to be copied
(NVRAM).
Specifies the destination of the file (the Flash
memory card in either slot 0 or slot 1) and the
name of the new file.
appear as the file is being copied. The
!!!
"Copying a Configuration File
3-85."
3-84