Cisco 12404 Installation And Configuration Manual page 141

Chapter 3 Installing the Cisco 12404 Internet Router
Configuration Changes
no ip routing
!
interface Ethernet0
no shutdown
ip address 172.88.99.2 255.888.255.0
!
interface POS1/0
shutdown
no ip address
!
interface SDCC1/0
shutdown
no ip address
.
.
.
interface POS15/0
shutdown
no ip address
!
interface SDCC15/0
shutdown
no ip address
!
end
[0] Go to the IOS command prompt without saving this script.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]:
Building configuration ...
Use the enabled mode 'configure' command to modify this configuration.
Filo#
You can enter the setup command at any time at the privileged EXEC prompt to
activate the setup command utility.
The only observable difference between the configuration script displayed when
Note
the setup command utility starts automatically on startup, and the script displayed
when you enter the setup command is that the existing script displays any
previously entered system configuration defaults within square brackets [ ].
Cisco 12404 Internet Router Installation and Configuration Guide
3-59
OL-11636-01