Cisco 12404 Installation And Configuration Manual page 183

Chapter 4 Troubleshooting the Installation
boot: image specified by the boot system command
or default to: cisco2-grp
do you wish to change the configuration? y/n [n]
You must reset or power cycle for the new config to take effect
rommon 1>
Initialize the router by entering the initialize command at the ROM monitor
Step 7
prompt:
rommon 1> initialize
•
Enter no in response to the system configuration dialog prompts until the
Step 8
following instruction is displayed:
Press RETURN to get started!
Press Return.
Step 9
After some interface configuration information is displayed, the user EXEC mode
prompt appears:
Filo>
Enter the enable command at the user EXEC mode prompt to enter privileged
Step 10
EXEC mode:
Filo> enable
Password: <password>
Filo#
The prompt changes from
command mode.
Note
OL-11636-01
The router goes through a power cycle. The software configuration register is
set to ignore the configuration file.
Note the greater than symbol
known as the pound sign)
Cisco 12404 Internet Router Installation and Configuration Guide
to to ( to
Filo> Filo# >
has changed to the number sign (also
>
.
#
Recovering a Lost Password
) indicates the change in
#
4-13