Configuration Register Settings - Cisco 12404 Installation And Configuration Manual

Performing Other Configuration Tasks

Configuration Register Settings

Step 1
Step 2
Cisco 12404 Internet Router Installation and Configuration Guide
4-6
or
cisco2-prp
.
.
.
cisco17-prp
The system would use one of the filenames in this range to use in booting a
•
default system image stored on a network TFTP server.
If a bootable Cisco IOS software image exists in a Flash memory card
Note
inserted in PCMCIA slot 0 or slot 1, the software configuration register
boot field setting is overridden, and the system boots from the Cisco IOS
software image in the Flash memory card, rather than from a network
TFTP image (that is, from a computed filename in the range from
cisco2-grp through cisco17-grp or cisco2-prp through cisco17-prp).
To change the software configuration register settings while running system
software, follow these steps:
Enter the enable command and your password at the user EXEC mode prompt to
enter privileged EXEC mode:
Milo> enable
Password: <password>
Filo#
Enter the configure terminal command at the privileged EXEC mode prompt on
the system console, to enter global configuration mode:
Filo# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Filo(config)#
Chapter 4 Troubleshooting the Installation
OL-11636-01