Assigning A Hybrid Port To A Vlan - H3C S5120-SI Series Configuration Manual

To do...
Enter
interface view
or port group
view
Configure the link type of the
port or ports as trunk
Assign the trunk port(s) to the
specified VLAN(s)
Configure the default VLAN of
the trunk port(s)
To change the link type of a port from trunk to hybrid or vice versa, you must set the link type to
access first.
After configuring the default VLAN for a trunk port, you must use the port trunk permit vlan
command to configure the trunk port to allow packets from the default VLAN to pass through, so
that the egress port can forward packets from the default VLAN.
After you configure a command on a Layer-2 aggregate interface, the system starts applying the
configuration to the aggregate interface and its aggregation member ports. If the system fails to do
that on the aggregate interface, it stops applying the configuration to the aggregation member ports.
If it fails to do that on an aggregation member port, it simply skips the port and moves to the next
port.

Assigning a Hybrid Port to a VLAN

A hybrid port can carry multiple VLANs. You can assign it to a VLAN in interface view or port group view.
Follow these steps to assign a hybrid port to one or multiple VLANs:
To do...
Enter system view
Enter Ethernet
Enter
interface view
interface
Use the command...
Enter
interface interface-type
Ethernet
interface-number
interface view
Enter Layer-2
interface bridge-aggregation
aggregate
interface-number
interface view
Enter port
port-group manual
group view port-group-name
port link-type trunk
port trunk permit vlan
{ vlan-id-list | all }
port trunk pvid vlan vlan-id
Use the command...
system-view
interface interface-type
interface-number
Required
Use either command.
Required
Required
By default, a trunk port carries
only VLAN 1.
Optional
VLAN 1 is the default VLAN by
default.
—
Required
1-8
Remarks
In Ethernet interface view, the
subsequent configurations
apply to the current port.
In port group view,
subsequent configurations
apply to all ports in the port
group.
In Layer-2 aggregate
interface view,
subsequent configurations
apply to the Layer-2
aggregate interface and all its
member ports.
Remarks
the
the