Configure Wrr Queuing - H3C S5120-SI Series Configuration Manual

To do...
Configure SP queuing
Configuration example
1) Network requirements
Configure GigabitEthernet 1/0/1 to adopt SP queuing.
2) Configuration procedure
# Enter system view
<Sysname> system-view
# Configure GigabitEthernet1/0/1 to adopt SP queuing.
[Sysname]interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] undo qos wrr

Configure WRR Queuing

Configuration procedure
Follow these steps to configure basic WRR queuing:
To do...
Enter system view
Enter
Enter
interface
interface
view
view or port
Enter port
group view
group view
Configure a WRR queue
Display WRR queuing
configuration information
on interface(s)
To guarantee that WRR correctly schedules queues according to their weights, make sure that the
queue IDs in each WRR group are contiguous.
Configuration example
1) Network requirements
Enable WRR queuing on the interface.
Use the command...
undo qos wrr
Use the command...
system-view
interface interface-type
interface-number
port-group manual
port-group-name
qos wrr queue-id group
group-id weight
schedule-value
display qos wrr interface
[ interface-type
interface-number ]
5-5
Remarks
Optional
The default queuing algorithm on an
interface is SP queuing.
Remarks
—
Use either command
Settings in interface view take effect
on the current interface; settings in
port group view take effect on all ports
in the port group.
Required
The default queuing algorithm on an
interface is SP queuing.
Optional
Available in any view