Displaying And Maintaining Vlan - H3C S5120-SI Series Configuration Manual

To do...
view or port
Enter Layer-2
group view
aggregate
interface view
Enter port
group view
Configure the link type of the
port(s) as hybrid
Assign the hybrid port(s) to
the specified VLAN(s)
Configure the default VLAN of
the hybrid port
To change the link type of a port from trunk to hybrid or vice versa, you must set the link type to
access first.
Before assigning a hybrid port to a VLAN, create the VLAN first.
After configuring the default VLAN for a hybrid port, you must use the port hybrid vlan command
to configure the hybrid port to allow packets from the default VLAN to pass through, so that the
egress port can forward packets from the default VLAN.
After you configure a command on a Layer-2 aggregate interface, the system starts applying the
configuration to the aggregate interface and its aggregation member ports. If the system fails to do
that on the aggregate interface, it stops applying the configuration to the aggregation member ports.
If it fails to do that on an aggregation member port, it simply skips the port and moves to the next
port.

Displaying and Maintaining VLAN

To do...
Display VLAN information
Display VLAN interface
information
Display hybrid ports or trunk
ports on the device
Clear statistics on a port
Use the command...
interface
bridge-aggregation
interface-number
port-group manual
port-group-name
port link-type hybrid
port hybrid vlan vlan-id-list
{ tagged | untagged }
port hybrid pvid vlan vlan-id
Use the command...
display vlan [ vlan-id1 [ to vlan-id2 ] | all |
dynamic | reserved | static ]
display interface vlan-interface
vlan-interface-id
[ ]
display port { hybrid | trunk }
reset counters interface
1-9
Remarks
Use either command.
In Ethernet interface view, the
subsequent
apply to the current port.
In port group
subsequent
apply to all ports in the port
group.
In Layer-2 aggregate interface
view, the
configurations apply to the
Layer-2 aggregate interface
and all its member ports.
Required
Required
By default, a hybrid port allows
only packets of VLAN 1 to pass
through untagged.
Optional
VLAN 1 is the default by default.
Remarks
Available in any view
Available in any view
Available in any view
Available in user view
interface-type
[
configurations
view, the
configurations
subsequent