Specifying The Radius Accounting Servers And Relevant Parameters - H3C S5120-SI Series Configuration Manual

It is recommended to specify only the primary RADIUS authentication/authorization server if
backup is not required.
If both the primary and secondary authentication/authorization servers are specified, the
secondary one is used when the primary one is unreachable.
In practice, you may specify two RADIUS servers as the primary and secondary
authentication/authorization servers respectively. At one time, a server can be the primary
authentication/authorization server for a scheme and the secondary authentication/authorization
servers for another scheme.
The IP addresses of the primary and secondary authentication/authorization servers for a scheme
cannot be the same. Otherwise, the configuration fails.

Specifying the RADIUS Accounting Servers and Relevant Parameters

Follow these steps to specify the RADIUS accounting servers and perform related configurations:
To do...
Enter system view
Enter RADIUS scheme view
Specify the primary RADIUS
accounting server
Specify the secondary RADIUS
accounting server
Enable the device to buffer
stop-accounting requests
getting no responses
Set the maximum number of
stop-accounting request
transmission attempts
Set the maximum number of
accounting request
transmission attempts
Use the command...
system-view
radius scheme
radius-scheme-name
primary accounting
ip-address [ port-number ]
secondary accounting
ip-address [ port-number ]
stop-accounting-buffer
enable
retry stop-accounting
retry-times
retry realtime-accounting
retry-times
1-20
Remarks
—
—
Required
Configure at least one of the
commands
No accounting server by default
Optional
Enabled by default
Optional
500 by default
Optional
5 by default