Displaying And Maintaining Basic Configurations - H3C S5120-SI Series Configuration Manual

When you configure the password for switching user privilege level with the super password
command, the user privilege level is 3 if no user privilege level is specified.
The password for switching user privilege level can be displayed in both cipher text and simple text.
You are recommended to adopt the former as the latter is easily cracked.
Modifying command level
All the commands in a view are defaulted to different levels, as shown in
can modify the command level based on users' needs to make users of a lower level use commands
with a higher level or improve device security.
Follow these steps to modify the command level:
To do...
Enter system view
Configure the command level in
a specified view
You are recommended to use the default command level or modify the command level under the
guidance of professional staff; otherwise, the change of command level may bring inconvenience to
your maintenance and operation, or even potential security problem.

Displaying and Maintaining Basic Configurations

To do...
Display information on system
version
Display information on the
system clock
Display information on terminal
users
Display the valid configuration
under current view
Display clipboard information
Display and save statistics the
running status of multiple
modules
Use the command...
system-view
command-privilege level
level view view command
Use the command...
display version
display clock
display users [ all ]
display this [ by-linenum ]
display clipboard
display
diagnostic-information
1-14
Table 1-3. The administrator
Remarks
—
Required
Refer to Table 1-3 for the
default settings.
Remarks
Available in any view