H3C S5120-SI Series Configuration Manual page 615

To do...
Enable the automatic saving of
the current running
configuration, and set the
interval
The path and filename prefix of a saved configuration file must be specified before you configure the
automatic saving period.
Saving the Current Running Configuration Manually
Automatic saving of the current running configuration occupies system resources, and frequent saving
greatly affects system performance. Therefore, if the system configuration does not change frequently,
you are recommended to disable the automatic saving of the current running configuration and save it
manually.
In addition, automatic saving of the current running configuration is performed periodically, and manual
saving can immediately save the current running configuration. Therefore, before performing
complicated configuration, you can manually save the current running configuration so that the device
can revert to the previous state when the configuration fails.
Follow the step below to save the current running configuration manually:
To do...
Save the current running
configuration manually
The path and filename prefix of a saved configuration file must be specified before you save the current
running configuration manually; otherwise, the operation fails.
Setting Configuration Rollback
Follow these steps to set configuration rollback:
To do...
Enter system view
Set configuration rollback
Use the command...
archive configuration
interval minutes
Use the command...
archive configuration
Use the command...
system-view
configuration replace file
filename
2-6
Remarks
Optional
Disabled by default
Remarks
Required
Available in user view
Remarks
—
Required