Table of Contents
Advertisement
Units:
Actual:
Target:
Error Messages :
occur. The errors are displayed on the last (4
shown on the 4
th
line on both 2-output and 3-output formats.
2-output format
Units:
Actual:
Target:
Error 5: Pt target exceeds knots limits
Profile Execution :
indicate the profile number and the point in the profile. This is done identically on both 2-
output and 3-output formats. A sample screen is shown below, where point number 12 of
profile number 3 is being executed. Notice that this sample screen shows some of the values
to be different from our previous sample screens. The essence of using profiles is that all the 7
parameters can be changed simply by moving to the next point in the profile, eliminating the
need to perform a lot of data entry.
2-output format
Units:
Actual:
Target:
Executing Profile 3.12 Lear-55 ADC
For more information on profiles, please refer to Section 4.
The Main operating screen will be used almost all the time during normal operation for
commanding target values, viewing actual values, setting units and modes.
knots
M
101.2
20.0
The Main screen is also used to display error conditions as they
knots
M
101.2
20.0
When a "profile" is being executed, the 4
knots
C
101.2
200.0
3
-output format
Feet
1006
M
10
th
) line of the display, as shown below. Errors are
Feet/min
3500
3000
Feet/min
3500
6000
24
Feet
1005
M
0
Feet
1005
M
0
th
line of the display will
Feet
1005
C
5000
Advertisement
Table of Contents
