Laversab 6600 User Manual page 33

will the value become effective.
If you change your mind and want to abort the new value entry, press CANCEL to exit the
value entry mode. You can press CANCEL even when the value is blinking. In the above
example, if you were to press CANCEL the old Pt target value of 20.0 will remain effective.
If there is an error in the value being entered then that error will be displayed on line 4 of the
display. To clear the error, enter CANCEL or CLR. This will also erase the erroneous value
and the previous value will stay in effect. Most errors are caused because a value entered is
outside the limits.
If the new value does not blink after pressing ENTER and no error message appears, then
there is a communication problem between the Remote unit and the main unit. Please abort
and contact the factory.
If new target values need to be entered for Ps1 and Ps2 then these should be entered and left
in the blinking state before pressing GO. This will enable the 6600 to start moving to the new
targets on all outputs simultaneously, when the GO key is pressed.
Ps1 target value:
formats. For entering Ps1 target values, press the Ps1 / ALTITUDE key. After the key is
pressed, the 2-output format will appear as shown below.
2-output format
Units:
Actual:
Target:
Now follow the same process for entering the value as described above in Numeric Value
Entry.
Note: The last effective Ps1 target value is retained through a power On/Off cycle.
Ps2 target value:
the Main Screen to the 3-output format using the PREV SCREEN key. In the 3-output format
the middle vertical section will show the units for Ps2 and will NOT indicate "/min". After
the screen shows the 3-output format, press the Ps2 / RATE key to enter the Ps2 target value.
After the key is pressed, the 3-output format will appear as shown below.
The Ps1 target value can be entered both in the 2-output and 3-output
knots
M 101.2
20.0
The Ps2 target value can be entered only in the 3-output format. Change
Feet/min
3500 1005
3000
26
Feet
M