Current Position Change; Absolute Address Specification; Relative Address Specification; Jump - Mitsubishi FX3U-20SSC-H User Manual

FX -20SSC-H Positioning Block User's Manual
3U
10.4

Current Position Change

This operation information item changes the current address (user/pulse) value to the one specified in the
position (address) information.
10.5

Absolute Address Specification

This operation information item sets the position data for subsequent table operations to be based on an
absolute address system with a defined (0, 0) point.
Note
• When table operation begins, the position information data is handled by the absolute address specification
(default). To use position information data with relative addresses, the operation information of positioning
control must be set beforehand.
• The arc center (i , j), radius r, Interrupt 1-speed constant quantity feed, and Interrupt 2-speed constant
quantity feed setting items are handled as relative addresses.
10.6

Relative address specification

This operation information item sets the position data of subsequent table operations to a relative address
based on the current address.
Point
When table operation begins, the position information data is handled by the absolute address specification
(default). To use position information data with relative addresses, the operation information of positioning
control must be set beforehand.
10.7

Jump

When executing this operation information item, the operation jumps to the specified table No..
Note that the table No. does not jump from X-axis table information to Y-axis table information.
Write the table No. of the jump point in the position information buffer memory location(s) for the applicable
table information.
(With FX Configurator-FP, set the table No. of the jump point by the Jump No.)
10.8

Dwell

When executing this operation information, operation waits for the specified time. A dwell is used as a wait to
move between operations.
Set the dwell time in the position information buffer memory location(s) for the applicable table information.
(With FX Configurator-FP, set the dwell by the Time.)
10 Table Operation
10.4 Current Position Change
113
1
2
3
4
5
6
7
8
9
10