Changing External Parts (5) Base Unit - ELNA CE10 Service Manual

Changing External Parts (5) Base Unit

1
1
3
2
5
6
Base
To remove:
1 Remove the Belt cover. (See page 2)
2 Remove Setscrew (A)
the base unit .
3 Remove the X Motor
from the printed circuit board (A).
1
2
3
4
5
6
To attach:
4 Attach the X, Y - Motor Connectors
the printed circuit board (A)
5 Insert the X, Y - Motor Cords between the printed
4
cuircuit board (A) and Arm without touching the jointing
points between arm and base, then tighten Screws
(4 pieces)
6 Attach the Extension (Accessory) table
7 Tighten Screws (B)
table, base unit and free Arm.
8 Tighten Screws
9 Attach the belt cover.
5
1 (4 pcs.), and remove
2 , Y Motor Connectors
Screw (A)
X-motor connector (Blue)
Y- motor connector (White)
Connecting Bushing
Extension table (Accessory)
Screw (B)
1 temporarily.
6 while aligning the extension
1
while aligning the extension table.
3
2
, into
3
.
5