DMX address
Operating mode 'Manual con‐
trol' (white LED model versions)
Wild Wash 132 LED RGB DMX, 132 LED White DMX, 648 LED RGB DMX,
This setting is only relevant if the device is controlled via a DMX controller.
Press [MODE] repeatedly until the currently set DMX address appears in the display ( 'Axxx' )
and press [ENTER]. Use [UP] and [DOWN] to select the desired DMX address between 1 ( 'A001' )
and 512 ( 'A512' ) and press [ENTER].
This setting is only relevant if the device is not controlled via a DMX controller and not working
as slave in a master / slave configuration. In this mode, the brightness of the white LEDs can be
adjusted and a Strobe effect can be engaged.
Press [MODE] repeatedly until 'C000' appears in the display and press [ENTER]. Use [UP] and
[DOWN] to select the menu item 'C1xx' for brightness or the menu item 'CFxx' for the Strobe
effect and press [ENTER].
To adjust the brightness, use [UP] and [DOWN] to select a value between 'C101' (minimum
brightness) and 'C199' (maximum brightness) or 'C100' (blackout, LEDs off) and press [ENTER].
To adjust the Strobe effect, use [UP] and [DOWN] to select a value between 'CF01' (Strobe fre‐
quency approx. 1 Hz) and 'CF99' (Strobe frequency approx. 30 Hz) or 'CF00' (continuous light,
no Strobe effect) and press [ENTER].
648 LED White DMX
Operating
29