Appendix B Specifications - Omron SYSMAC C2000H Operation Manual

AD001 through AD005 Analog Input Modules
All general specifications of the AD001 through AD005 conform to those of the C Series except the following:
• Insulation resistance between the external terminals and the frame: 5 MΩ min. (at 250 VDC)
• Dielectric strength between the external terminals and the frame: 500 VAC, 50/60 Hz for 1 minute
Number of analog inputs
Input signal range (See Note 1.)
Input impedance
Resolution
PLC signal
Linearity error
Accuracy
Accuracy temperature coefficient
Conversion time
Conversion cycle
Max. PLC write delay (See Note 2.)
Conversion method
Max. input signal
External connections
Power consumption
Weight
Note
Appendix B
Specifications
2
Voltage inputs
Current inputs


Voltage input:: 1 M


Current input: 250
1/4095 (full scale)
12-bit binary (for bipolar outputs, 11-bit binary + 1 sign bit.)
±
0.1% max.
±
0.2% max. (full scale at 25
± °
100 PPM/ C (full scale)
2.5 ms max./port
5 ms max.
1 s
Sequential comparison
±
Voltage input: 15 V
±
Current input: 60 mA
Terminal block (not removable)
500 mA max. at 5 VDC
600 g max.
The PC write delay is the time required for a change in the input signal to be
converted and transferred to the PLC bus.
Analog input
0
Digital output
(to PLC)
0000
1 to 5 V (AD001)
0 to 10 V (AD002)
0 to 5 V (AD003)
--10 to 10 V (AD004)
--5 to 5 V (AD005)
4 to 20 mA (AD001)
min.
°
C)
Time
Conversion
cycle
A filter inside the Module
causes
the digital signal to increase
in a stepwise fashion.
PC write delay
Time