Entering Net2Phone Account And Isp Information - HCL Yap Jack Plus User Manual

Yap Jack Plus User's Guide – Chapter 2
To set up and connect your device:
Entering Net2Phone Account and
ISP Information
Now that you're all connected, you need to configure the
device with your Net2Phone account and ISP information
so that you can place calls.
If you try to place a call before the information has been
entered, the device will perform a check, and if any
information is missing, you will be prompted to enter each
field one at a time.
One of the new features in Yap Jack Plus, version 1.2.5 is
the ability to specify two different sets of ISP information:
Primary ISP and Backup ISP. If you have two separate
ISP accounts, you will be able to enter one account's
information (ISP phone number, name, password, and
access type) as the Primary ISP and the other account's
information as the Backup ISP. If you only have one ISP
account, you can enter your account information as the
Primary ISP and then use the Backup ISP to specify a
secondary access number.
1. Connect the Yap Jack Plus into your telephone
jack.
??
Plug one end of the telephone cable (RJ-11)
into the Line port on the back of the device.
??
Plug the other end into a working telephone
wall jack.
2. Connect your telephone into the Yap Jack Plus.
??
Plug the RJ-11 cable from your telephone
into the Phone port on the back of the
device.
3. Power-up the Yap Jack Plus.
??
Plug the power supply into an AC outlet and
plug its power cable into the DC IN port on
the rear of the device.
The device powers-up immediately. You will
hear three beeps, the lights will glow, and
the display will read Initializing
Please Wait... and then Yap Jack Plus
* Ready *.
12