If Something Fails To Work - Teka VTN DC User Manual

If something doesn't work
GB
Before calling the Technical Service, please
make the following checks:
Fault
FOR ALL THE MODELS:
Neither the hotplates nor the pilot lights are working
Message ER 25 and the beeping signal
The pan is sticking to the glass
MODELS TT 600, TT 630, TB 600, TR 600, TC 620 and TR 735 AB:
Message ER 21 on the control and subsequent disconnection
Message ER 03 on the control and the beeping signal. Control disconnection
A L appears on the control and it does not work
38
Possible cause
The cable is not connected
to the mains
Surges in the electricity
supply network
Something has melted
between the pan and the
glass.
Pans with aggressive bases.
If, whilst cooking, the tempe-
rature of the control electro-
nics gets too high, it will dis-
connect to avoid damage.
Overheating problems only
occur while cooking under
extreme conditions of use
(cooking for a long time at
full power).
There is an object or liquid
covering up the touch
control.
The control is blocked.
Possible solution
Connect the cable to the
mains
Contact the Technical
Service
Set the hotplate to full power
and try to unstick it.
Check the bases of your
pans and do not slide them
across the glass.
Leave the hob to cool
down for a few minutes. If
the problem persists, check
that installation was perfor-
med in compliance with the
instructions in this manual.
Remove the object or liquid
that is covering the touch
control.
Follow the instructions to
unblock the control.