Remote Cooking - Teka VTN DC User Manual

by touching sensor
immediately after activating the touch con-
trol. This should be done within 5 seconds
after activating the touch control with the
on/off sensor (1), and the blocking
function will be cancelled and the control
disconnected. If this is not done properly,
the touch control will remain blocked and
after 20 seconds will disconnect.
The blocking has been deactivated. When
the sensor is reactivated with the on/off
sensor (1), the hob will be ready to be
used for cooking.
Disconnection for safety purposes
If one or more areas have, in error, not
been switched off, the unit automatically
disconnects after a certain length of time
(see table 4).
When this safety disconnection has taken
0
place, a appears if the temperature on
the surface of the glass is of no danger to
H
the user, or a appears if there is, indeed,
a risk of burning.
Table 4
Power Maximum Operating
Selected
1 and 2
3 and 4
5
6, 7, 8 and 9
To use the appliance again, use the on / off
sensor (1) to switch it off, and then
switch it back on again.

Remote Cooking

(Starting cooking automatically)
This feature enables you to do your coo-
king while you yourself are not present.
for 5 seconds
Time (In hours)
6
5
4
1,5
The touch control pre-programs the selec-
ted hotplate to full power and then decrea-
ses it to the power you have chosen after
a certain length of time (see table 5).
Table 5
Power Start Automatic Cooking
Selected Feature (Time in mins.)
1
2
3
4
5
6
7
8
9
SWITCHING ON REMOTE COOKING
1 Activate the hotplate you wish to use (2).
9
2 Select power and then touch sensor
The power light will flash on and off,
alternating between 9 and A; now use
sensor to lower it to the constant
cooking level you want - 6, for example.
The indicator light will flash on and off,
alternating between
Example:
You want to cook at power level
begin with rapid heating. Select power
touch sensor again and the power indi-
cator will flash on and off, alternating bet-
9 A
ween and , then decrease it to power 6
using sensor . The system will keep the
hotplate at power 9 (maximum) for 2.5
minutes, flashing on and off alternately
6 A
between and , then (after 2.5 mins.) it
will automatically decrease to constant
6
cooking level .
1
3
4,8
6,5
8,5
2,5
3,5
4,5
---
6 A
and .
6
and
9
,
27
GB