Connecting The Electricity; Joining The Hob To The Oven; Or Control Panel - Teka VTN DC User Manual

GB

Connecting the electricity

Before connecting the hob to the electric
mains, check that the voltage and fre-
quency of the mains matches what is
shown on the hob's rating plate, which is
located lower down, and on the guarantee
certificate or, where appropriate, the tech-
nical datasheet supplied, which should be
kept together with this manual.
The electric connection is made via an
omnipolar switch or plug where accessi-
ble, which is suitable for the intensity to be
tolerated and which has a minimum gap of
3 mm between its contacts, which will
ensure disconnection in case of emer-
gency or when cleaning the hob.
The connection should include correct ear-
thing, in compliance with current norms.
If the flexible supply cable fitted to the VT CM
hob model ever needs to be changed, it
should be replaced by TEKA's official service.
The input cable should not be in contact
either with the body of the hob or with the
body of the oven, if the oven is installed in
the same unit.

Joining the hob to the oven

or the control panel.
For this purpose, four cardan telescopic
shafts are included with the hob. (See fig.
5). The way to join them is as follows:
1 Turn off the electricity.
2 Detach the cardan telescopic shafts by
pressing on the retention clip (A), where
it says PUSH, with a slim screwdriver,
and pull the extension out a few centi-
metres.
3 Remove the four pins from the ends (B).
18
fig. 5
4 Put the oven part-way into its space,
taking care not to drag the cardan teles-
copic shafts coming from the hob, and
leaving enough space to put in the other
ends of the telescopic shafts into the
shafts in the rear part of the control
panel, and then replace the pins. (See
fig. 5)
5 To make the electric connection betwe-
en the two appliances, attach the hob's
connector to oven's connector.
6 Complete the definitive positioning of
the oven, ensuring that the cardan teles-
copic shafts are firmly in position and
that the telescopic pipes are well-alig-
ned when inserted so that sliding is
quite simple.
7 Position the controls on the front of the
oven.
8 To operate the control knobs, they first
have to be pressed in, and then turned
in order to release the safety device.
Retention clips
Pins