Installation; Positioning The Hobs - Teka VTN DC User Manual

Installation

Important
INSTALLATION AND SETUP SHOULD
BE CARRIED OUT BY AN AUTHORISED
TECHNICIAN IN LINE WITH CURRENT
INSTALLATION STANDARDS.

Positioning the hobs

Depending on the model to be installed, an
opening with the dimensions shown in
figure 2 will be cut into the unit's worktop.
The system for fixing the hob is intended
for use with kitchen units with a thickness
of 20, 30 and 40 mm. In the packaging of
the models VTN DC, VT HDC2 and TC
620, there is a template included that is for
use in sizing the space for these glass
ceramic hob models.
To position the VS U and TS 600 hobs into
the kitchen unit, the gap will need to be of
the following size: length - between 560
and 580 mm; and width - between 480 and
492 mm. See the fiting hole's dimensions
for each model on the "dimensions and
characteristics" table of this manual.
The minimum distance between the surfa-
ce supporting the cooking pans and the
lower part of the kitchen unit or the hood
located above the hob should be 650 mm.
If the hood's installation instructions
recommend that the gap is greater than
this, you should follow this advice.
The hobs described in this manual can
only be installed with Teka ovens. Models
with no control knobs are only to be insta-
lled with Teka ovens and/or Teka control
panels.
The unit where the hob and oven will be
located will be suitably fixed.
INSTALLATION WITH A CUTLERY DRA-
WER OR LOW CUPBOARD
Minimum distances
to walls
Minimum ventilation
distances
minimun 40 mm
OVEN
minimun 40 mm
minimun 40 mm
OVEN
fig. 1
If you wish to have a cupboard or cutlery
drawer beneath the hob, you should install
a panel to separate them. This will prevent
accidental contact with the hot surface of
the body of the appliance.
The board should be installed 20 mm
GB
15