Table of Contents
Advertisement
Copyright © 2017, Juniper Networks, Inc.
NOTE:
Figure 47 on page 148
PoE capability when the switch is viewed from the top. The internal
components and top cover are not shown. The procedure to mount the
switch on a wall and the distance between mounting screws are the same
for EX2300 switches with 24 ports with and without PoE capability though
the depth of the chassis of the switches with and without PoE capability
are different.
NOTE:
Tighten the screws only part way in, leaving about 1/4 in. (6 mm)
distance between the head of the screw and the wall.
Drill a hole A and install a mounting screw.
a.
Drill a hole B at a distance of 5.98 in. (15.2 cm) on a level line to the right from screw
b.
A and install a mounting screw.
Drill a hole C at a distance of 18.67 in. (47.43 cm) on a plumb line down from screw
c.
A and install a mounting screw.
Drill a hole D at a distance of 18.67 in. (47.43 cm) on a plumb line down from screw
d.
B and install a mounting screw.
Chapter 12: Installing the Switch
shows an EX2300 switch with 24 ports with
147
Hide quick links:
Advertisement
Table of Contents
