Installing The Power Switch - Dell PowerEdge T30 Owner's Manual

Steps
1 Remove the power-switch cable from the chassis clip.
2 Remove the screw securing the power switch to the chassis.
3 Slide the power switch down to disengage it from the slot and pull out the power switch from the system.
Figure 12. Removing the power switch
Next steps
1 Connect the power-switch cable to the system board.
2 Install the bezel
3 Install the power switch.
4 Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing the bezel
Installing the bezel

Installing the power switch

After working inside your system
Installing the power switch
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Keep the Phillips #2 screwdriver ready.
Steps
1 Insert and route the power-switch cable through the chassis clip.
2 Slide the power switch through the slot on the front of the system and secure it to the system.
3 Connect the power-switch cable to the power-switch connector on the system board.
46 Installing and removing system components