Table of Contents
Advertisement
Next steps
If the problem persists, see the Getting help section.
Related links
Using system diagnostics
Getting help
Removing the system cover
Installing the system cover
Troubleshooting the system battery
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE:
If the system is turned off for long periods of time (for weeks or months), the NVRAM may lose its system configuration
information. This situation is caused by a defective battery.
NOTE:
Some software may cause the system time to speed up or slow down. If the system seems to operate normally except
for the time set in System Setup, the problem may be caused by a software, rather than by a defective battery.
Steps
1
Re-enter the time and date in System Setup.
2
Turn off the system, and disconnect it from the electrical outlet for at least an hour.
3
Reconnect the system to the electrical outlet, and turn on the system.
4
Enter System Setup.
If the date and time displayed in System Setup are not correct, check the System Error Log (SEL) for system battery messages.
Next steps
If the problem persists, see the Getting help section.
Related links
System Setup
Getting help
Troubleshooting power supply units
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
The following sections provide information on troubleshooting power source and power supply units problems.
Troubleshooting power source problems
1
Press the power button to ensure that your system is turned on. If the power indicator does not glow when the power button is
pressed, press the power button firmly.
2
Plug in another working power supply unit to ensure that the system board is not faulty.
3
Ensure that no loose connections exist.
For example, loose power cables.
4
Ensure that the power source meets applicable standards.
5
Ensure that there are no short circuits.
6
Have a qualified electrician check the line voltage to ensure that it meets the needed specifications.
Troubleshooting your system
99
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
